Editing GameCube controller
From SmashWiki, the Super Smash Bros. wiki
Jump to navigationJump to search
|
You aren't logged in. While it's not a requirement to create an account, doing so makes it a lot easier to keep track of your edits and a lot harder to confuse you with someone else. If you edit without being logged in, your IP address will be recorded in the page's edit history. | |
 Log in
|
Create account
| |
The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then publish the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 85: | Line 85: | ||
====Analog sticks==== | ====Analog sticks==== | ||
Control stick and C-stick make up the three most important parts: the stick itself, the stick box it is attached to, and the potentiometers the stick box is attached to. | Control stick and C-stick make up the three most important parts: the stick itself, the stick box it is attached to, and the potentiometers the stick box is attached to. | ||
The shape of the stick box prevents the value extremes from being achieved, and the octagonal shape on the outer shell of the controller further cuts down the effective input range to approximately 25-230. This range varies from controller to controller and decreases with use as the friction between the inner stick box parts creates a gap and thus a loose zone. Because of this, a worn-down | The shape of the stick box prevents the value extremes from being achieved, and the octagonal shape on the outer shell of the controller further cuts down the effective input range to approximately 25-230. This range varies from controller to controller and decreases with use as the friction between the inner stick box parts creates a gap and thus a loose zone. Because of this, a worn-down controller's stick will push the potentiometer less than a fresh controller's stick. | ||
====Screws==== | ====Screws==== | ||
